Repair immediately (major defects):
Nearside Rear Brake pipe excessively corroded (1.1.11 (c))
Offside Rear Brake pipe excessively corroded both rear brake line (1.1.11 (c))
Rear Tyre(s) with different structures are fitted across the same axle (5.2.3 (c))
Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer seal (6.1.1 (c) (i))
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer seal (6.1.1 (c) (i))
Offside Front Suspension locking device missing lower arm ball joint split pin missing (5.3.6 (b))
Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))
Monitor and repair if necessary (advisories):
Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Front Lower Gearbox mounting defective
Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement top mount (5.3.4 (a) (i))
Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))
Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))
Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))
Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))
So yea, pretty bad.
The thing is it is a nice little run around lol. I dont wanna scrap it because i'd prob get like £200. Could try selling it for £400.. maybe but still be nice to keep it..
So, yea just curious what everyone else thinks. It has def been touched up before and i'm not capable of welding that. The other stuff I am not too concerned about but I dont wanna spend £800 welding it just for it to go again.
