Clubjazz - Honda Jazz & HR-V Forums
Honda Jazz Forums => Honda Jazz Mk1 2002-2008 => Topic started by: guest5562 on July 28, 2015, 01:56:17 PM
-
Just bought new Pagid discs and pads from Eurocarparts for the front.
Job going fine until I tried to get the caliper over the new pads... the combination of disc, pads & 3 anti-squeal shims is too thick to get the caliper on. It's not that the piston isn't far enough back... the casting itself is binding. Well I say it won't go on... it will hammer on but obviously the brakes will be rubbing.
I've checked out and I have the correct parts & there are no fitting errors. The only thing I can think is that.... there is a thick shim on the back of either old pad and an extra thin one on the inner pad. Haynes says to refit these 3 but I wonder if they aren't needed or expected to be fitted with the Pagid pads so the pads themselves are a little thicker. If I leave off the two thicker shims it will all fit OK. So that's what I'll do and then see if they'll fit in a few weeks when its all bedded in.
Wonder if anyone's fitted Pagid and been OK or seen the problem?
-
Well sorted now.
It seems there is no doubt Pagid didn't expect the thicker pair of anti-squeal shims to be re-fitted from the old pads so have dimensioned their thickness to take up the whole space available. Their disc was the correct 21mm thickness so no error there.
I have re-fitted the thin anti-squeal shim that's on the piston side and that fits in fine.
Brakes work fine and no squeal but I have saved the old shims in case squeal starts and I can re-fit them when a little wear gives some clearance.
I see Pagid have started to paint their discs (silver) since I last fitted a pair so they should look better through the alloys for longer than unpainted.