Well, I got my Rota RB's re-fitted.
Saturday morning I removed the rear bumper and fitted my alloys in preparation of having the arch work done.
As you can see, it all looks pretty clean under there. Not bad for a 10 year old car.
Dan (from Arch Enemy) came over just after lunch. It took him about 3 hours in total to roll and grind the rear arches, then roll & pull the front arches (also trimming the liners).
Here are the results...
Rear arches rolled, ground and sealed (gaining about 15mm clearance):
Front arches rolled, pulled and linings trimmed (gaining 15mm-20mm clearance):
After his work yesterday, this is how the car looked:
I test fitted the rear bumper this morning and took my car out for a quick drive.
Unfortunately the un-modified bumper was rubbing quite badly at the back. :-
I quickly popped the bumper off, trimmed about 6" out of the inside and cut the liners accordingly.
Plenty of clearance now. No rubbing!
Front:
Rear:
Side:
I'm really happy how it turned out.
Shouldn't have any more problems.