Just failed MOT on rear nearside bearing and lambda readings(exhaust blowing a little, hope this is the reason)
Haynes manual states I need to use new nut(£13) after replacing bearing, does new one come along with bearing or it could be reused? or is it locking nut?
still very much undecided wich way to go with 10yo car £35ebay/£110halfords/£165honda..
EDIT:
if anyone could confirm nut size as 30mm, would be nice, seen 2 refs to 32mm on US sites, maybe different models..
EDIT 2:
was wrong re halfords quote, it's £137 actually, to replace bearing only, 12k miles/1y warranty..
therefore ordered 42200SAAG02 off coxmotorparts at discounted £137.96
they were most helpful, confirmed that:
-
old nut could be reused-
nut size is 32mmEDIT 3:
all done
nut size was
30mm