Author Topic: Exhaust Head Shroud  (Read 79 times)

jonathan

  • Approved Member
  • *
  • Posts: 110
  • Country: gb
  • My Honda: Honda Jazz 1.4SE
Exhaust Head Shroud
« on: February 14, 2018, 08:40:38 AM »
Does anyone know where I can get a heat shroud which fits on the middle section of the car.

Here are some photos of it.

On two and the three bolts have come away from the shroud.....

culzean

  • Approved Member
  • *
  • Posts: 3282
  • Country: england
Re: Exhaust Head Shroud
« Reply #1 on: February 14, 2018, 08:57:19 AM »
Does anyone know where I can get a heat shroud which fits on the middle section of the car.

Here are some photos of it.

On two and the three bolts have come away from the shroud.....

Is there any chance you can get the bolts out ?   if so try these to cover corroded hole.

https://www.diy.com/departments/nails-screws-and-hardware/bolts-nuts-and-washers/washers/repair-penny-washers/diameter-3mm/diameter-5mm/_/N-e16Z1z13vlfZ1z13vl9

When a normal (welded to exhaust pipe) shroud has broken and making a  'zinging' noise at certain revs I have used hose clamp to fit it back on - (even joined two together if not long enough).

https://www.screwfix.com/p/t-mex-stainless-steel-worm-drive-hose-clips-40-80mm-10-pack/67161
Some people will only consider you an expert if they agree with your point of view or advice,  when you give them advice they don't like they consider you an idiot

sparky Paul

  • Approved Member
  • *
  • Posts: 275
  • Country: gb
  • My Honda: 2008 GE3 Jazz 1.4 i-DSI SE
Re: Exhaust Head Shroud
« Reply #2 on: February 14, 2018, 09:20:36 AM »
I usually make something similar to the penny washers by cutting squares out of scrap steel about 1 - 2 inch square, drilling a hole in the centre and turning up the corners so they grip what's left of the heat shield.

Not sure what the fasteners are, but if they are the push-on starlock type fasteners, you can get replacements for these. If the studs are too corroded, you may have to resort to improvising some other method of fixing.

Tags:
 

Back to top