« previous next »
Pages: [1]

Author Topic: Alloy Wheel fitting  (Read 1495 times)

guest6255

  • Guest
Alloy Wheel fitting
« on: August 09, 2016, 03:19:42 PM »
So i bought some KEI Racing alloy wheel 17' for the jazz, and went to get them fitted and the wheel nuts what come standard dont fit my new alloys, any advice you could give or where i could get these wheel nuts?
Report to moderator   Logged

guest1372

  • Topic Starter
  • Guest
Re: Alloy Wheel fitting
« Reply #1 on: August 09, 2016, 05:25:22 PM »
Most aftermarket alloy wheels use a 60° taper.  Probably best to phone up a performance store that sells Kei and ask. e.g. Demon Tweeks etc.
You may also needs spigot rings, the Jazz centre bore is 56.1mm, your universal wheel is probably larger; without them balancing and safety is compromised.

--
TG
Report to moderator   Logged

Garyman

  • Approved Member
  • *
  • Posts: 1406
  • Country: gb
  • My Honda: 2009 1.4 ES
Re: Alloy Wheel fitting
« Reply #2 on: August 10, 2016, 09:51:14 AM »
What TG said  :D

The standard wheel nuts will not fit aftermarket alloy wheels- you will need aftermarket wheels nuts as well.

Also as recommended by TG- best to get some spigot rings while you're at it but they are fairly cheap- anything from £5-20 for the set.
Report to moderator   Logged
Pages: [1]
« previous next »
Tags:
 

anything
Back to top