Hi
Our jazz is the SI, but the wiring (of using TG advice as we did), is very easy and simple to do, with no additional work to wire to fuse box
I suppose it depends upon the DRL controller, which my controller needed a battery and ignition on feed, so I soldered and hear shrink the battery wire to the ignition on wire, then crimped this to the green power feed to the head light level feed on the headlight (top left at rear of light cluster), so this feed both, allowing the DRL only working on IG2 (when dashboard lights come on or engine is running), but off on IG1 key position (kudos to TG for this)
I did initially crimp the indicator light but disconnected this because the DRL flashed when indicating, which is illegal in UK to have flashing white lights on indicators I believe
Last wire to crimp was to the sidelight, so the DRL dimmed to 50%
I would advice you remove the front wheel, remove the wheel arch liner, and fit your DRL, which from what I can see, you will need to drill a small hole, for wire feed, unless you may be able to feed the wire through where your fog lights are, but I'm not sure as our is the SI with different bumper.
I hope it goes well for you, and would be good if you could post pics to help others if you do fit them
Many thanks
John